![]() ![]() Twist this over the wire, holding it in place. Get a twist connector from an electronics store (a small conical cap).Twist the two strands of wire together.With a wire stripper, strip about ½ inch (1.25cm) of insulation from each cut end.Using wire cutters, cut the wire on either side of the broken socket.If you don't feel comfortable removing light bulb sockets, then you can just leave a light bulb in the socket or cover it with electric tape to prevent an electric shock.) Follow this method: (Note that a damaged wire or a repair using this method, unless done well, may present an electric shock or fire hazard. Removing this is not as difficult as it sounds, although each bulb you remove will cause the remaining bulbs to burn more brightly and therefore burn out sooner though removing one or two bulbs should be fine. If a new bulb still won't light up, your socket may be corroded or the wire may be damaged nearby. Only problem is then fixing a place for the blacked out. Mark this bulb with tape so you don't lose track, then replace this bulb as described below. I found some black covers that fit over mini lights so you can reduce any number of lights in a string. Repeat until you find a bulb with current on one side of it and no current on the other.Moisture in the outlet, lights or a cord can cause a breaker to. If it happens again, you should find another outlet so you don’t overload the circuit. If that’s the case, just reset the breaker. Move the tool to the middle of the problem area and test again, narrowing it down to ¼ of the string. If you plug in a strand of lights and it doesn’t work, check the breaker box to make sure you haven’t blown a fuse.If there is no hum or light, the problem is in the half closest to the plug. An LED light tester can also be used to identify which bulb or socket is not properly functioning. If an LED tree is not lighting, check to make sure all wires are plugged in and fuses are securely seated. Mini light testers do not work on LED trees. ![]() If the tool hums or lights up (depending on model), the problem is in the half of the string farthest from the plug. LED light strings feature one piece construction, which can make troubleshooting limited.(If your tool has a small hole for a detector, place a light bulb into the hole instead. Place the detector on this wire about halfway along the string, between two bulbs.Once the bulb is fully seated in the base, fold the copper wires against the base in the same position as noted above. Make sure the two copper wires are completely aligned with the holes in the bulb's base. If some of your landscape lights aren’t working there are a few options we can try. Insert the replacement bulb into the old bulb's socket. If that doesn’t work then you may need a new timer. Tug apart the braided wires to identify the one directly connected to the light bulbs. First, we’d try resetting it by pressing the Reset, Restart, or R button in your transformer.This detects the current running through the wires, so you can identify the point where it fails. Some other common reasons might include: The light switch has stopped working. If the string of lights still won't light up, move on to the detector. The socket tab got flattened, and it’s not making contact with the light bulb.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |